Document Type : Research Article
Authors
1
Marine structures department, marine engineering faculty khorramshhahr univeristy of marine science and technology
2
Master of Science in Water and Hydraulic Structures Engineering, Department of marine structures, Faculty of Marine Engineering, Khorramshahr University of Marine Science and Technology, Khorramshahr, Khuzestan, Iran
3
Department of Naval Architecture, Faculty of Marine Engineering, Khorramshahr University of Marine Science and Technology, Khorramshahr, Khuzestan, Iran
10.30482/jhyd.2026.602948.1789
Abstract
Hydraulic jumps are widely used in stilling basins to dissipate excess kinetic energy downstream of hydraulic structures; however, the geometry of the stilling basin can strongly influence the required tailwater depth, jump length, and energy dissipation. This study presents a numerical and statistical assessment of hydraulic jumps in rectangular and trapezoidal diverging stilling basins, with emphasis on the competing hydraulic effects of divergence angle, inlet Froude number, cross-sectional geometry, and trapezoidal side slope. Three-dimensional simulations were performed using STAR-CCM+ based on the Reynolds-averaged Navier–Stokes equations, the standard \(k-\varepsilon\) turbulence model, and the Volume of Fluid method for free-surface tracking. Divergence angles of 3°, 5°, 7°, and 9° were examined over inlet Froude numbers of approximately 3.7–10. For trapezoidal sections, side-slope ratios of \(Z=0.5:1\), \(1:1\), and \(1.5:1\) were considered. The numerical framework was evaluated through grid-sensitivity analysis, turbulence-model comparison, and validation against available experimental measurements. For a representative 7° rectangular smooth-bed case, the numerical errors in initial depth, sequent depth, jump length, and mean velocity were approximately 5.56%, 4.20%, 3.70%, and 4.00%, respectively, while discrepancies across the broader validation dataset were generally below 6%.
The results showed that increasing the divergence angle generally reduced the sequent-depth ratio and relative jump length while increasing relative energy loss. In rectangular basins, the mean reductions in sequent-depth ratio and relative jump length were approximately 19.41% and 24.54%, respectively, and the mean increase in relative energy loss was approximately 26.47% compared with the corresponding classical reference jump. For the trapezoidal basin with \(Z=0.5:1\), the corresponding mean improvements were approximately 21.95%, 22.72%, and 34.04%, respectively. Although larger divergence angles generally enhanced hydraulic performance, the energy-dissipation response was not strictly monotonic for every Froude number, indicating that the interaction between lateral expansion, momentum redistribution, and roller development affects the dissipation process.
Regression-based response-sensitivity analysis showed that divergence angle was the dominant explanatory variable for several hydraulic responses, particularly for relative jump-length reduction in rectangular basins, for which the strongest regression model yielded \(R^2=0.934\). In contrast, the relatively low explanatory power obtained for energy-loss enhancement in the trapezoidal \(Z=0.5:1\) configuration indicated that Froude number and divergence angle alone were insufficient to represent the full complexity of the dissipation mechanism.
A weighted design-performance index was also used to examine the trade-off among sequent-depth reduction, jump-length reduction, and energy dissipation. Under equal weighting, the rectangular and trapezoidal 9° configurations produced nearly identical overall performance indices, showing that a unique optimum geometry cannot be identified from a single composite score. Instead, the rectangular configuration is more favorable when reduction of basin length is emphasized, whereas the trapezoidal configuration provides greater energy dissipation. These findings demonstrate that diverging stilling-basin design should be treated as a multi-objective hydraulic design problem in which geometry is selected according to project-specific constraints and priorities.
Keywords
Subjects